Skip to content
How To Change Battery In Mazda Key Fob 2007. Carefully insert the new battery with the positive side up. Remove the key fob battery cover from your mazda remote.
It’s easy to change the battery once you open the mazda key fob: Then insert the flathead into the gap and slide to pop the top. The key remote should separate into two pieces.
Table of Contents
Push The Auxiliary Key Button On The Back Of The Mazda Key Fob And Remove The Metal Auxiliary Key.
Make sure the positive (+) symbol is facing you. Press the button for the auxiliary key. You can use this key to access your vehicle if your key fob battery is dead.
Stick The Head Of The Flathead Screwdriver Into One Of The Slots On Either Side Of The Key Fob.
Place the back mazda key fob case aside. You’ll find it on the back of the key fob. With the metal key gone, you’ll notice a slot on either side of the key fob case.
Refer To This Guide From Tulley Mazda And Your New Fob Will Be Functioning Properly In No Time!
Because the notch may not be visible, this is the most difficult aspect. Refer to this guide from tulley mazda and your new fob will be functioning properly in no time! Press the auxiliary key button on the back of your key fob.
Once The Battery Is Replaced, Reverse These Steps To Put The Key.
Without damaging the small rubber ring that the battery rests on, remove the now fully exposed mazda key fob battery. Carefully insert the new battery with the positive side up. Locate the small knob at the back of the key fob and press it down while sliding out the mechanical key.
Determine The Kind Of Battery.
Now you can pry the battery out of the battery compartment and replace it. The positive is on top, while the negative side of the button cell. Use a tiny flat blade screwdriver to pry.
