How To Drain An Above Ground Pool Using The Pool Pump. While some people recommend you use your pool pump to drain the water, we highly recommend not doing this. Follow the above first two steps.
Place the other end of the first hose into the drainage area. Start off by unrolling your pump’s intake hose all the way to the center of the pool and submerge the same into the water. The second (or third) step is to attach a pump to the garden hose and then submerge it into your swimming pool and begin to pump out water.
Table of Contents
Using One, Or Two, Or Three, Or However Many Garden Hoses You Have, Refill Your Pool.
Check the hose to make sure the water’s draining properly. Frequently check the draining process to make sure the water level drops and. First of all, find your sewer drainage pipe and connect it to the pump using a hosepipe.
Place The Other End Of The First Hose Into The Drainage Area.
Submerge one end of the first hose into the pool and secure it in place. An electric pump or a garden hose siphon. Use small submersible electric pump and garden hose, or b).
This Area Should Be Away From The Pool And The Ground Should Be Level To Avoid Flooding.
It’s time to change your liner. But once the water falls below the skimmer level, the skimmer will still try to suck in water. Turn the pump back on and let the water run until it reaches the point where you want to drain the water out.
Drop The Hose (Or Each Hose If You Are Using More Than One) Underwater.
492.8 pounds | frame type: Connect the hose pipe to sewer and pump. Check that the water flow isn’t cut off.
Attach A Pump To The Hose.
Turn the pump on and watch as the pool is slowly emptied of water. Submerge the pump’s intake hose under the water, as close to the center of the swimming pool as possible. Turn the electric pump on with clean, dry hands.