close
close
How To Light A Water Heater With Electronic Pilot Rheem

How To Light A Water Heater With Electronic Pilot Rheem

How To Light A Water Heater With Electronic Pilot Rheem

How To Light A Water Heater With Electronic Pilot Rheem. Dial or rotate the gas control knob to the pilot position. Comes on steady, hot and strong.

How To Light A Water Heater With Electronic Pilot RheemHow To Light A Water Heater With Electronic Pilot Rheem
How to Reignite Your Water Heater's Pilot Light from www.mrrooter.com

Release the button and if the pilot continues to burn, turn the dial to the on position. How to relight your water heater pilot light for every major brand 1 tom plumber. Depress the gas control knob.

You're Working Blind If You Can't Get In.

Make sure the switch labeled “pilot” or “on/off” is turned on, then press and hold the electronic pilot light button. On a modern rheem gas water heater, it is very easy to light the pilot light. Comes on steady, hot and strong.

How To Relight Rheem Stellar Gas Hot Water You.

When the flame ignites, continue to hold the gas knob or button down for a full minute. Push down the red button to the left of the gas knob. After you have done that, push the button.

You Should Hear A Whooshing Sound As The Burner Ignites.

Follow the steps below to light your water heater pilot:had to shut gas down at meter to install a gas range.hold it in while you light the pilot with a match or the piezoelectric control on the heater.hold the red button down while pressing the piezo ignitor striker, found to the immediate right of the gas knob, repeatedly until the pilot is lit. How to light a water heater pilot light. Use a flashlight or a headlamp to find the burner inside.

See also  How To Soften Hard Aquarium Water

This Will Allow The Flame To Ignite.

Keep on doing this until you see that the status light begins to blink every few seconds. If so, make sure that the circuit is on. This whole process will take approximately 1 minute for a newly installed unit.

When The Flame Ignites, Continue To Hold The Gas Knob Or Button Down For A Full Minute.

Hold the red button down while pressing the piezo ignitor striker, found to the immediate right of the gas knob, repeatedly until the pilot is lit. Release the button and if the pilot continues to burn, turn the dial to the on position. When you see this, it means that the.

Leave a Reply

Your email address will not be published.